Monday morning. Someone opens the vaccine fridge for the first appointment and notices the thermometer reads well above where it should. Nobody knows when that started. Was it Sunday afternoon, or Saturday night after the last client left? Were the rabies and combination vaccines on the top shelf affected, or only the ones near the door?
Without a vaccine fridge temperature log, nobody can answer those questions, and the clinic is left choosing between throwing out stock it may not need to lose and injecting doses that may not work. A short log sheet and a written drill for bad readings remove the guesswork. This is how to set both up.
How a vaccine fridge drifts without anyone noticing
Vaccine fridges rarely fail dramatically. They drift. The door doesn't latch after a rushed evening restock. The plug gets nudged half out during floor cleaning. A power cut runs longer than the inverter covers, or the fridge was never on the inverter in the first place. A door seal perishes over a hot summer, or a thermostat gets bumped while someone reaches for the back row.
None of this is carelessness. It happens because the fridge belongs to everyone, so it belongs to no one. The receptionist assumes the nurse checks it, and the nurse assumes the vet does. A thermometer that only shows the current reading makes things worse, because by mid-morning the fridge may have recovered and the overnight problem has left no trace.
The range matters at both ends. Stock packed tight against the cooling vent can get too cold just as easily as a door left ajar lets it get too warm, and a label's storage range has a floor as well as a ceiling.
The log sheet: columns and who fills it in
Tape a printed sheet to the fridge door, one per month, with these columns:
- Date
- Time
- Minimum (since last reset)
- Maximum (since last reset)
- Current reading
- Initials
- Action taken
The routine comes from CDC's Vaccine Storage and Handling Toolkit. It is written for human vaccines, but the discipline carries over. CDC says to check and record the minimum and maximum temperatures at the start of each workday. If your thermometer has no min/max memory, it says to record the current temperature at least twice per workday, at the start and at the end.
In practice, the first person in reads the minimum and maximum, writes them down, initials the line, and then resets the thermometer if it needs resetting. Order matters here. Resetting before recording wipes the overnight evidence. If your thermometer only shows the current temperature, add a closing reading to your end-of-day closing routine so it happens alongside cash-up rather than as a separate chore someone forgets.
If a reading is missed, leave that line blank. CDC's toolkit says the same. A blank line is honest and tells you there's a gap to look at. A number written in later from memory is worse than nothing, because it hides exactly the window when something might have gone wrong.
What the safe range is
The safe range is the one printed on each vaccine's label or package insert, so check yours. As a reference point, CDC's toolkit says vaccine refrigerators must stay between 2°C and 8°C (36°F and 46°F) at all times. Write the range you are working to at the top of the log sheet, so nobody has to look it up when a reading looks odd.
Where vaccines sit inside the fridge
Placement causes more problems than people expect. CDC's toolkit advises against storing vaccines in parts of the unit with unstable temperatures or poor airflow: directly under cooling vents, in vegetable or produce drawers, and on door shelves.
So keep vaccines on the middle shelves, in their original boxes, with a little space around them for air to move. Keep the door shelves empty, or use them for water bottles that help hold the temperature steady. Don't store staff lunches or sample pots in the vaccine fridge. Every extra opening is another few seconds of warm air.
The excursion drill: what to do with a bad reading
Write this on a card and tape it next to the log sheet. When a reading is out of range, nobody should have to make up a response on the spot.
- Tell the vaccine lead straight away. One named person, with a named deputy for days off.
- Label the exposed vaccines DO NOT USE. Move them into a separate box inside a fridge that is in range. Do not throw them away.
- Write it down. Note the time you found it, the fridge reading, the room temperature, how long the excursion may have lasted (use the last good reading on the log), and the lot numbers of every vaccine affected.
- Fix the cause. Check the door, the plug, the seal and the thermostat. If you can't find the cause, treat the fridge as unreliable until you do.
- Call each vaccine manufacturer before using any exposed dose. Have your log in front of you. Record who you spoke to, when, and what they said, in the action column and in the excursion note.
The "don't discard, don't use" step comes directly from CDC's toolkit. It says exposed vaccines should be kept in a separate container and not discarded, and should not be given unless the manufacturer advises that safety and effectiveness were not compromised. A short excursion may turn out to be fine for some products and not for others. The manufacturer decides, not the person who found the reading.
This is where the min/max column earns its place. A manufacturer will ask how high the temperature went and for how long. A sheet showing the maximum since yesterday's reset, plus the last good reading, gives them something to work with. A sheet showing only "looked fine" doesn't.
The lot numbers you'll need
An excursion is a records test as much as a fridge test. You need to know which lots were in the fridge. If a manufacturer later says a dose may have been compromised, you also need to know which patients received those lots. Recording batch numbers at goods receipt and at administration is covered in our post on batch and lot tracking for veterinary medicines. It's the column people skip until the day they need it.
If you keep stock in MyCliniCore, inventory is held by batch with expiry dates, so the list of lots on hand is a stock report rather than a box-by-box hunt through the fridge. The temperature log itself stays on paper on the fridge door, where the person opening up will actually see it. You can see the inventory side on the features page.
Filing the sheets and spotting repeat problems
At month end, the vaccine lead takes the sheet down, checks it for blanks and out-of-range lines, signs it, and files it with any excursion notes stapled behind. CDC's toolkit advises keeping temperature logs for 3 years to track trends and recurring issues.
Trends are the real payoff. One excursion is an incident. The same fridge creeping warm every Monday points to a weekend power pattern. Highs that cluster on delivery days point to stock being loaded with the door wide open. Blank lines that keep falling on one person's shifts point to a training gap. You only see these patterns by laying several months of sheets side by side.
A five-minute start for tomorrow
- Print a log sheet with the columns above and tape it to the fridge.
- Name a vaccine lead and a deputy, and write both names on the sheet.
- Check that your thermometer has min/max memory. If it doesn't, add a closing reading to the day-end routine.
- Move anything sitting in the door, the drawers or under the vent onto the middle shelves.
- Tape the excursion drill next to the log.
A good fridge log protects the vaccine. The next question is whether every vaccine you give actually reaches the invoice. If you'd like a rough sense of what slips through at a clinic your size, the free 60-second audit gives an estimate based on industry benchmarks. It doesn't look at your clinic's own data, so treat it as a starting point for your own day-end check, not a measurement.